ACI Fabric Setup: Lesson 3: ACI Controller Demo Part 2

     

     

    Lesson 3: ACI Controller Demo Part 2

    Presented by Robert Burns

     

    ACI Fabric Setup: Lesson 3: ACI Controller Demo Part 2In this third video training lesson in the Application Centric Infrastructure (ACI) Fabric Setup session presented by Robert Burns, you will see part 2 of 2 of the ACI Controller Demo.  In the demo, Robert continues with the fabric discovery and, while using his network diagram as a guide, adds the remaining leaf notes to the fabric.  Once he’s finished adding all of the leaf and spine nodes, he goes on to add a second Application Policy Infrastructure Controller (APIC) to the fabric.  Next, he explains how important it is to set up NTP (Network Time Protocol) and walks through the steps.  Robert wraps up this video lesson with a look at how to set up a fabric policy for your exporting and how to configure firmware policies.

     

    Lesson 1: Overview of the ACI Fabric

    Lesson 2: ACI Controller Demo Part 1

    Lesson 3: ACI Controller Demo Part 2

    Lesson 4: Questions and Answers

    Watch more ACI Training Videos

    Watch ACI How-To Videos