-
1. Re: How to connect my Cisco 2500 to my existing network???
Conwyn Apr 23, 2009 1:14 PM (in response to Chad)Hi Chad
I think you can only connect via Ethernet. Do you have a Ethernet or AUI port on your 2500. If you have a AUI you will need a transceiver which convers AUI to RJ45. The Lynx may have a little bank of Ethernets if not you will need a switch or a cross-over cable.
Regards Conwyn
-
2. Re: How to connect my Cisco 2500 to my existing network???
Scott Morris - CCDE/4xCCIE/2xJNCIE Apr 23, 2009 1:33 PM (in response to Chad)2500 series routers are not modular. So a WIC card can't help you at all!
You can connect via the DB-60 serial connection (although I don't think any Linksys routers have these) or you can connect via ethernet.
So grab an ethernet transciever (AUI to RJ45) and plug yourself into the linksys! Then plug your other router/switches in and have fun playing!
Scott
-
3. Re: How to connect my Cisco 2500 to my existing network???
Chad Apr 23, 2009 1:36 PM (in response to Conwyn)Thanks I have a transceiver also and some crossover cables, which is very hard to find in stores, so this should work out a lot just have to figure it out, thanks Conwyn you are very helpful.
-
4. Re: How to connect my Cisco 2500 to my existing network???
Chad Apr 23, 2009 1:47 PM (in response to Scott Morris - CCDE/4xCCIE/2xJNCIE)Thanks Scott, I am going to play with it for a long time, I just going to have to figure this thing out, a lot of reading to do, lol.
Thanks,
Chad