Skip navigation
Cisco Learning Home > Certifications > Routing & Switching (CCNA) > Discussions

_Communities

600 Views 6 Replies Latest reply: Apr 30, 2012 10:51 PM by Martin RSS

Currently Being Moderated

FR Hub and Spoke

Apr 30, 2012 7:59 AM

Gonzo 291 posts since
Oct 10, 2008

Hello,

 

I'm created a frame relay network, what do I need to do to make it into a hub and spoke network?  I was thinking of making London the hub.  Would I just remove DLCI 203 from New Youk and 302 from Tokyo?

 

fr1.JPG

 

Thanks

Attachments:
  • Currently Being Moderated
    1. Apr 29, 2012 1:25 AM (in response to Gonzo)
    Re: FR Hub and Spoke

    Hey Gonzo, here is a quick little flash movie that demonstrates the configs you need to get up an running in no time...

    http://cdn.firstdigest.com/swf/cisco-frame-relay/ospf-fr-hs.htm

     

    Kevin

  • Kumar Mantri 311 posts since
    Jan 6, 2011
    Currently Being Moderated
    2. Apr 30, 2012 5:07 AM (in response to Gonzo)
    Re: FR Hub and Spoke

    Hi Gonzo,

     

    The DLCI mapping between newyork and tokyo are used to reach eachother,if it is a hub-to-spoke topology then both reach via LONDON or else if u configure one dedicated link bettween them in frame relay cloud ,so if u have dedicated framerelay line between them configured in framrelay ,remove it then this will become hub-to-spoke topology,

     

    Regards.

    kumarmantri

  • Edsel 9 posts since
    Apr 28, 2012
    Currently Being Moderated
    5. Apr 30, 2012 10:15 AM (in response to Gonzo)
    Re: FR Hub and Spoke

    HI Guys, So fresh and new on this forum, Anyway you're right right for Hub and spoke you can remove 203/302 dlci otherwise this topology would likely be a  point to point connectivity as of full mesh. As Kumar mentioned is right spoke connectivity would go directly to london as a pass - through to other spoke

     

    Thanks.

  • Martin 13,070 posts since
    Jan 16, 2009
    Currently Being Moderated
    6. Apr 30, 2012 10:51 PM (in response to Gonzo)
    Re: FR Hub and Spoke

    It is OK if you have other PVCs; just do not use them on purpose of accidentally if you want to hub-spoke;

    often you get multiple DLCIs from ISP, choose right one for your goal;

     

    in fact, all rental-gear sites have full mesh so u can choose topology to use; full-, partial-mesh or hub-spoke, or hybrid;

    often, assigning unused DLCIs  to unused sub-interface is good pracitce in real life and on CCIE lab.

Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)