11 Replies Latest reply: Aug 16, 2019 2:48 PM by Conwyn RSS

    E1 interface problem ...!!!

    Jorge

      Good afternoon, I'm new to the forum so I apologize if it is well written the error, review the discussions and did not get any with my problem which I explain below:

       

      I have a cisco 2800 router configured as a gateway to a small plant, is configured in an E1 that is having problems with incoming calls and after a while so constantly block must be restarted to free channels , below shows a view of the driver.

       

      I hope you can help me, thanks.

       

      CC-XXX#sho controllers e1

      E1 0/0/0 is up.

        Applique type is Channelized E1 - balanced

        Cablelength is Unknown

        Description: CPA-CANTV

        No alarms detected.

        alarm-trigger is not set

        Version info Firmware: 20071011, FPGA: 13, spm_count = 0

        Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.

        CRC Threshold is 320. Reported from firmware  is 320.

        Data in current interval (872 seconds elapsed):

           0 Line Code Violations, 0 Path Code Violations

           13 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

           13 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

        Total Data (last 24 hours)

           0 Line Code Violations, 0 Path Code Violations,

           892 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

           892 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs