1 2 Previous Next 15 Replies Latest reply: Aug 7, 2019 12:51 PM by PaulDK RSS

    Virl 1.3.296 console of nodes only shows the prompt - not able to issue commands

    PaulDK

      Hi,

       

      I am running Virl 1.3.296. I have build a simple topology consisting of router linked to a nexus 9000 switch. When I start a simulation the devices cycle to the Active state. When I then right-click the devices and try to telnet to the console port; the console opens but the only thing that happens is that the prompt is blinking in the console, no config is shown and I am not able to issue commands from the prompt.

        1 2 Previous Next