• Implementing Cisco IP Switched Networks (300-115)

    Implementing Cisco IP Switched Networks (300-115)  Exam Description  Implementing Cisco IP Switched Networks (SWITCH 300-115) is a 120-minute qualifying exam with 45‒55 questions for the Cisco CCNP Routing ...
    Madhukar: Cisco Team
    last modified by Madhukar: Cisco Team
  • SWITCH v2.0 Study/Learn

    Welcome to the Study/Learn tab for the SWITCH v2.0 exam page. This page has been designed to help you find what you are looking for faster by organizing the content according to the exam topics.       ...
    Madhukar: Cisco Team
    last modified by Madhukar: Cisco Team
  • 300-115 SWITCH

    300-115 SWITCH  Exam Number: 300-115 Associated Certifications: CCNP Routing and Switching and CCDP Duration: 120 minutes (30 - 40 questions) Available Languages: English Register for Exam: Pearson VUE Exam Polic...
    Madhukar: Cisco Team
    last modified by Madhukar: Cisco Team
  • (642-813) SWITCH Exam Topics

    Implementing Cisco IP Switched Networks (642-813)Exam Description  The 642-813 exam is a two-hour test with 35−45 questions. Implementing Cisco IP Switched Networks (SWITCH 642-813) is a qualifying exam for...
  • SWITCH v2.0 Practice

    About Practice   Use the following review questions, taken from the current SWITCH curriculum, to help prepare for the exam. These review questions do not reflect the actual questions you will receive on the liv...
    Madhukar: Cisco Team
    last modified by Madhukar: Cisco Team
  • How to configure Vlan, Trunk between Cat OS & IOS

    Hello ,   can any body help me to configure vlan, trunk between Cat OS & IOS switches.     Thanks in Advance,   Suresh
    suresh
    last modified by suresh
  • Switching Based

    what type of data traffic includes BPDUs ANSWER:- Network management
    Loknadh
    last modified by Loknadh
  • STP question: is the information provided by BPDUs stored on a per-port basis for each switch?

    When I first started reading about/studying STP I thought that BPDUs were only received on root ports and designated ports. I later learned that all ports (even blocking ports) received BPDUs. Someone had explained to...
    Chih
    last modified by Chih
  • Where is the VTP configuration revision number stored?

    The textbook explaining is a little vague and confusing and apparently this issue has cause a bit of a problem for others as well. The book had the following to say about where VTP information is stored: I took thi...
    Chih
    last modified by Chih
  • Semantics? "Which type of links should be built between switches in the distribution and core layers of a campus network? (Choose all that apply)"

      I went ahead and assumed that layers 1-3 would be needed as layer 3 depends on layers 1 and 2 and layer 2 depends on layer 1 etc making the first 3 layers valid answers. The problem here is that this question ...
    Chih
    last modified by Chih
  • Voice VLAN configuration question

    This figure provided in the chapter shows the 4 different configuration options for voice VLANs. In the caption above the Catalyst switch it says "Special 802.1Q trunk CoS in 802.1p bits" and there is an arrow pointin...
    Chih
    last modified by Chih
  • in the End-to-End VLAN method for scaling VLANs in switch blocks is the VLAN membership static or dynamic?

    Screen shot.   In chapter 4 VLANs and Trunks, section Virtual LANs of the CCNP SWITCH Offical Cert Guide, following the subsection on VLAN membership it gets into VLAN Deployment and discusses two methods: (1) E...
    Chih
    last modified by Chih
  • I missed this practice question regarding Enterprise Campus Design. Looking for discussion

    Here is the question.   I was initially going to choose C and D, but I specifically remember the text saying that though the number of peer switches a core switch has IS an issue of concern for routers, in reali...
    Chih
    last modified by Chih
  • CCNP SWITCH 300-115 discount coupons

    hi everyone,   Planning to take CCNP switch v2 exam this month.Any possible ways to get some discounts
    UMA
    last modified by UMA
  • best practices config template for external switch

    Hi All I am currently configuring a switch stack to terminate the public side of my network Can anyone recommend a template of best practices similiar to this for a router https://www.cymru.com/Documents/secure-...
    donaghq
    last modified by donaghq
  • dot1x Configuration and Troubleshooting

    I'm a CCNA, currently studying for my CCNA security.  I work as a Desktop technician, and often we have to have dot1x disabled/enabled to authorize our clients.  I was curious, and It looks like it's a littl...
    Ben
    last modified by Ben
  • networks.pawan@gmail.com

    Hi All,   I gave CCNP Routing exam in Aug 2013. Please let me know what will be the last month/year of completing the switching and T-shoot exam.??     Regards, Pawan Vashisht
    Pawan
    last modified by Pawan
  • Trunk Port Security

    02:45:51: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down 02:45:51: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down 02:45:51: %LINEPROTO-5-UPDOWN: Li...
    Mr. Bill Kaplan
    last modified by Mr. Bill Kaplan
  • CCNP Switch v2 Lab recommendations

    Hi All,   I am Planning to do the New Switch v2 exam. Is there any recommendations for the new Switching lab ? Are there any changes in lab gears since they moved to IOS 12 to 15 ? Existing switches (IOS 12) i...
    Sajith
    created by Sajith
  • Study Materials for v2.0

    Hi,   I am currently prep'n for CCNP exams using the foundation Learning Guides by Cisco Press for the older version of the exams (642-XXX), and I have seen the new exams v2.0 objectives and I thought it would b...
    Mohamed
    last modified by Mohamed